This page is in the root address (192.168.4.1 or the router’s given IP) and decodes the received data from module to the audio stream.Īfter opening the page, wait for a few seconds for the initial file loading. In case of using a strong microphone module or loud input audio, there’s no need to the software amplitude.“Audio Stream Software Amplitude” increases the sound volume of the output data. The “Audio Stream Packet Length” sets the stream time in 5, 10, 30 or 60 minutes. The signal strength must be higher for higher quality.With “Audio Stream Bitrate” the quality of the audio stream can be set in 96, 108 or 120Kbps. The stream configuration is in the bottom of “settings” page: The “Hidden HotSpot” button will set the module’s hot spot as hidden hotspot and the “Disable HotSpot when is connected to the modem” would disable the module’s hotspot, when is connected to the modem. (Example: the secure link is ABCD and the root page would be at 192.168.4.1/ABCD/ address) Also you can set a password for the internal page with Secure Link section. In the “Device Hot Spot Configuration” section, you can set the module hotspot’s SSID and password. The given IP address for the above picture is 192.168.0.12. This page is also available via the DHCP IP of the module.The module would connect to the modem after about 30 seconds in case of validity of ssid and password. In the “Modem Configuration” section, you’re able to view/edit the SSID and password of WiFi modem/router and then click on “Save” after inserting. Also in this page you can configure the hotspot connections and recording settings. This page shows the WiFi connection status, available access points and etc. “Settings” will lead you to the WiFi and device configuration page: MicPage.ino (Microphone’s page and the decoder).
0 Comments
Leave a Reply. |